Read the docs
TI-2022-24431 Aliases CVE-2022-48910GHSA-23g6-fhm7-588p

net: ipv6: ensure we call ipv6_mc_down() at most once

Priority LOW 24Published · Updated

Key facts

Attack vector
Local
Privileges required
Low
User interaction
None
Attack complexity
Low
Impact type
—
Confidentiality · integrity · availability
None · None · High
Fix status
Partial Red Hat: 3 without a fix

Attack profile from CVSS 3.1 · NVD. Fix status from CNA and Red Hat.

Summary

In the Linux kernel, the following vulnerability has been resolved: net: ipv6: ensure we call ipv6_mc_down() at most once There are two reasons for addrconf_notify() to be called with NETDEV_DOWN: either the network device is actually going down, or IPv6 was disabled on the interface. If either of them stays down while the other is toggled, we repeatedly call the code for NETDEV_DOWN, including ipv6_mc_down(), while never calling the corresponding ipv6_mc_up() in between. This will cause a new entry in idev->mc_tomb to be allocated for each multicast group the interface is subscribed to, which in turn leaks one struct ifmcaddr6 per nontrivial multicast group the interface is subscribed to. The following reproducer will leak at least $n objects: ip addr add ff2e::4242/32 dev eth0 autojoin sysctl -w net.ipv6.conf.eth0.disable_ipv6=1 for i in $(seq 1 $n); do ip link set up eth0; ip link set down eth0 done Joining groups with IPV6_ADD_MEMBERSHIP (unprivileged) or setting the sysctl net.ipv6.conf.eth0.forwarding to 1 (=> subscribing to ff02::2) can also be used to create a nontrivial idev->mc_list, which will the leak objects with the right up-down-sequence. Based on both sources for NETDEV_DOWN events the interface IPv6 state should be considered: - not ready if the network interface is not ready OR IPv6 is disabled for it - ready if the network interface is ready AND IPv6 is enabled for it The functions ipv6_mc_up() and ipv6_down() should only be run when this state changes. Implement this by remembering when the IPv6 state is ready, and only run ipv6_mc_down() if it actually changed from ready to not ready. The other direction (not ready -> ready) already works correctly, as: - the interface notification triggered codepath for NETDEV_UP / NETDEV_CHANGE returns early if ipv6 is disabled, and - the disable_ipv6=0 triggered codepath skips fully initializing the interface as long as addrconf_link_ready(dev) returns false - calling ipv6_mc_up() repeatedly does not leak anything

Why it matters now

Exploitation None reported CISA SSVC · not in CISA KEV
EPSS 0.0021 11th percentileScored 2026-11-07
Fix Partial Linux (Linux): 4.9.313, 4.14.278, 4.19.323 +5Red Hat: 3 without a fix

SSVC decision points

CISA ADP · SSVC 2.0.3

Exploitation
None
Automatable
No
Technical impact
Partial

The decision (Track, Attend, Act) also depends on your mission and well-being impact; see CISA's SSVC guide.

Affected products

VendorProductAffected versionsFixed inStatusSource
LinuxLinux3.18 and later4.9.313, 4.14.278, 4.19.323, 5.4.193, 5.10.104, 5.15.27, 5.16.13, 5.17Patch availableCNA
  • Linux VendorLinux Affected 3.18 and later Fixed in 4.9.313, 4.14.278, 4.19.323, 5.4.193, 5.10.104, 5.15.27, 5.16.13, 5.17 Patch available CNA

CPE configurations NVD · 7

CPEVersionsRoleVendor
cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*3.18 to before 4.9.313; 4.10 to before 4.14.278; 4.15 to before 5.4.193; 5.5 to before 5.10.104; 5.11 to before 5.15.27; 5.16 to before 5.16.13VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc1:*:*:*:*:*:*5.17 rc1VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc2:*:*:*:*:*:*5.17 rc2VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc3:*:*:*:*:*:*5.17 rc3VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc4:*:*:*:*:*:*5.17 rc4VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc5:*:*:*:*:*:*5.17 rc5VulnerableLinux
cpe:2.3:o:linux:linux_kernel:5.17:rc6:*:*:*:*:*:*5.17 rc6VulnerableLinux
  • cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* Versions 3.18 to before 4.9.313; 4.10 to before 4.14.278; 4.15 to before 5.4.193; 5.5 to before 5.10.104; 5.11 to before 5.15.27; 5.16 to before 5.16.13 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc1:*:*:*:*:*:* Versions 5.17 rc1 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc2:*:*:*:*:*:* Versions 5.17 rc2 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc3:*:*:*:*:*:* Versions 5.17 rc3 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc4:*:*:*:*:*:* Versions 5.17 rc4 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc5:*:*:*:*:*:* Versions 5.17 rc5 Vulnerable ·Linux
  • cpe:2.3:o:linux:linux_kernel:5.17:rc6:*:*:*:*:*:* Versions 5.17 rc6 Vulnerable ·Linux

Remediation

  • Fix · CNA Linux (Linux) Fixed in 4.9.313, 4.14.278, 4.19.323, 5.4.193, 5.10.104, 5.15.27, 5.16.13, 5.17

Vendor assessments

Red Hat

Red Hat rating: Moderate. Red Hat's page for this CVE →

ProductStatusPlan or fix
Red Hat Enterprise Linux 6AffectedNo fix planned: Out of support scope
Red Hat Enterprise Linux 7AffectedNo fix planned: Out of support scope
Red Hat Enterprise Linux 8AffectedNo fix planned: Will not fix
Not affected: 1 product
  • Red Hat Enterprise Linux 9

Timeline

  1. 2026-10-02 Threatist record created from CVE-2022-48910
  2. 2026-10-03 Alias added: GHSA-23g6-fhm7-588p

References

  • TI-2025-26358 tls: fix handling of zero-length records on the rx_list KEVCVSS 3.1CRITICAL 9.8
  • TI-2026-38352 netfilter: bridge: make ebt_snat ARP rewrite writable KEVCVSS 3.1HIGH 8.8
  • TI-2013-05264 The (1) get_user and (2) put_user API functions in the Linux kernel before 3.5.5 on the… KEVCVSS 3.1HIGH 8.8
  • TI-2022-00125 Integer overflow in kernel KEVCVSS 3.1HIGH 8.4
  • TI-2013-01864 The perf_swevent_init function in kernel/events/core.c in the Linux kernel before 3.8.9… KEVCVSS 3.1HIGH 8.4
  • TI-2021-05514 Heap Out-Of-Bounds Write in Netfilter IP6T_SO_SET_REPLACE KEVCVSS 3.1HIGH 8.3
See all 15278 →

Sources