Read the docs

Permanent transmit loss in NXP ENET QoS driver after link drop

Priority LOW 28CWE-772Published · Updated

Key facts

Attack vector
Adjacent network
Privileges required
None
User interaction
None
Attack complexity
Low
Impact type
Denial of service
Confidentiality · integrity · availability
None · None · High
Fix status
Fixed

Attack profile from CVSS 3.1 · CNA. Fix status from CNA. Impact type from CWE-772.

Summary

Zephyr from 3.7.0 before 4.3.2 and from 4.4.0 before 4.5.0 has a flaw in its NXP ENET QoS Ethernet driver where a transmit semaphore is never released if a frame in flight is lost at link drop (CWE-772). An adjacent attacker controlling the link partner or cable, with no credentials, can trigger this link transition and leave the interface unable to transmit until reset, even after the link returns.

Written with Claude Haiku 5.5 from the sources below · 2026-11-09

Description from the CNA

The NXP ENET QoS Ethernet driver in drivers/ethernet/eth_nxp_enet_qos serialises transmission with a binary semaphore, data->tx.tx_sem, taken in eth_nxp_enet_qos_tx() and returned only by the transmit-completion interrupt handler tx_dma_done(). A frame that has been handed to the transmit DMA when the Ethernet link goes down is never written back, so that completion interrupt never arrives. The PHY callback eth_nxp_enet_qos_phy_cb() reacts to carrier loss only by calling net_eth_carrier_set(); it does not stop the DMA, take the descriptors back or release the outstanding frame, and no timeout exists to do so. The trigger is a link-down/link-up transition that lands while a frame is under the transmit DMA. It can be produced by anyone who controls the link partner or the cable — for example by administratively downing and restoring the attached switch port, or by restarting auto-negotiation from a peer device — and can be made reliable by generating traffic that keeps the device transmitting and repeating the transition. No credentials or user interaction are required, and the trigger is at the link layer rather than over IP. Because the semaphore is never given back, every subsequent call to eth_nxp_enet_qos_tx() fails with -EBUSY for the remaining life of the boot; restoring the link does not recover the interface, since the link-up path only rewrites MAC_CONFIGURATION. The affected interface continues to receive but can no longer transmit anything — no ARP replies, no TCP acknowledgements, no DHCP renewals — until the device is reset. The net_pkt and the net_buf fragments of the abandoned frame are likewise never unreferenced and never return to their pools. The security-relevant property is persistence: a momentary link flap leaves the interface permanently unable to send, so the denial of service outlasts the attacker's access to the link. There is no confidentiality or integrity impact. The fix adds a claim/release pair around the outstanding packet so that completion and abandonment are mutually exclusive, aborts an outstanding frame from the PHY callback on carrier loss (stopping the DMA, flushing the MTL transmit queue and reinitialising the descriptor ring), and arms a transmit watchdog, CONFIG_ETH_NXP_ENET_QOS_TX_TIMEOUT_MS, so that any non-completing DMA — not only a carrier loss — reclaims the transmit slot and the packet.

Why it matters now

Exploitation None reported CISA SSVC · not in CISA KEV
EPSS 0.00175 7th percentileScored 2026-11-16
Fix Fixed zephyr (zephyrproject): 4.3.2, 4.5.0

SSVC decision points

CISA ADP · SSVC 2.0.3

Exploitation
None
Automatable
No
Technical impact
Partial

The decision (Track, Attend, Act) also depends on your mission and well-being impact; see CISA's SSVC guide.

Affected products

VendorProductAffected versionsFixed inStatusSource
zephyrprojectzephyr3.7.0 to before 4.3.2; 4.4.0 to before 4.5.04.3.2, 4.5.0Patch availableCNA
  • zephyr Vendorzephyrproject Affected 3.7.0 to before 4.3.2; 4.4.0 to before 4.5.0 Fixed in 4.3.2, 4.5.0 Patch available CNA

CPE names Threatist (inferred) · 1

Inferred from how NVD named this product before; not given by a source.

CPEVersionsRoleVendor
cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:*——zephyrproject
  • cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:* Versions — — ·zephyrproject

Remediation

Fixed versions are Zephyr 4.3.2 and 4.5.0. Upgrade affected installations to one of these releases.

Written with Claude Haiku 5.5 from the sources below · 2026-11-09

  • Fix · CNA zephyr (zephyrproject) Fixed in 4.3.2, 4.5.0

Fixed in the same release

Records fixed by the same vendor advisory or release, as the CNA lists them.

  • Release ·

    zephyrproject zephyr 4.3.2, 4.5.0

    6 records Highest priority Priority LOW 6 LOW

    Other records, highest priority first

    • TI-2026-87402 Zephyr NXP ENET-QOS Ethernet driver writes to invalid DMA addressPriority LOW 39
    • TI-2026-87397 Uninitialized pointer in Zephyr Xtensa MMU allows out-of-bounds writesPriority LOW 35
    • TI-2026-87400 Zephyr leaks thread stack mappings when another thread aborts itPriority LOW 24

Timeline

  1. 2026-11-09 Threatist record created from CVE-2026-90590
  2. 2026-11-11 Priority changed: MEDIUM → LOW
  3. 2026-11-12 CISA SSVC decision points changed

References

  • TI-2026-04422 Out-of-bounds read/write in HTTP WebSocket upgrade via non-null-terminated Sec-WebSocket-Key CVSS 3.1CRITICAL 9.8
  • TI-2026-01361 dns: memory‑safety issue in the DNS name parser CVSS 3.1CRITICAL 9.8
  • TI-2026-09174 Unterminated URI buffer causes out-of-bounds read in LwM2M firmware pull (Package URI) CVSS 3.1CRITICAL 9.1
  • TI-2026-09168 Stack buffer overflow in `net_ipaddr_parse()` IPv4 address-with-port parsing in `subsys/net/ip/utils.c` CVSS 3.1CRITICAL 9.8
  • TI-2024-09625 net: lib: http_server: Buffer Under-read CVSS 3.1HIGH 8.6
  • TI-2021-02863 Usb bluetooth device ACL read cb buffer overflow CVSS 3.1CRITICAL 9.6
See all 366 →

Sources

This product uses the NVD API but is not endorsed or certified by the NVD. Sources and licences