Read the docs

Type confusion in Zephyr Virtual L2 VLAN frame handling

Priority LOW 24CWE-686Published · Updated

Key facts

Attack vector
Adjacent network
Privileges required
None
User interaction
None
Attack complexity
High
Impact type
—
Confidentiality · integrity · availability
None · Low · High
Fix status
Fixed

Attack profile from CVSS 3.1 · CNA. Fix status from CNA.

Summary

Zephyr from 4.2.0 before 4.3.2 and from 4.4.0 before 4.5.0 has a type confusion in Virtual L2 receive handling, causing an indirect call with wrong argument types (CWE-686). A host on the same link can trigger it with a tagged Ethernet frame for a VLAN interface that is down, without authentication. This causes crashes and memory corruption in the network receive path.

Written with Claude Haiku 5.5 from the sources below · 2026-11-16

Description from the CNA

The Virtual L2 receive handler virtual_recv() in subsys/net/l2/virtual/virtual.c ends with a fall-through path meant for a virtual interface that has nothing attached below it: it takes net_if_get_device(iface)->api, treats it as a struct virtual_interface_api, and calls api->recv(iface, pkt). That handler is however also invoked with a non-virtual interface: ethernet_recv() in subsys/net/l2/ethernet/ethernet.c deliberately passes the Ethernet interface so that a tagged frame can be dispatched over the VLAN interfaces attached to it. For an Ethernet interface dev->api is a struct ethernet_api, whose layout only shares the leading struct net_if_api, so the slot read as recv is actually get_config() (default) or get_capabilities() (when CONFIG_NET_STATISTICS_ETHERNET is enabled). The fall-through is reached whenever no attached virtual interface claims the frame - most simply when the VLAN interface owning the frame's tag exists but is administratively down, since net_eth_get_vlan_iface() resolves the tag without checking link state while virtual_recv() skips interfaces that are not up. Any host able to place an 802.1Q-tagged Ethernet frame on the same link can then trigger the mistyped indirect call; no authentication, IP reachability or user interaction is required, because the frame is consumed at L2 before any address check. The resulting call passes a struct net_if where the driver expects a struct device and a struct net_pkt where it expects a struct net_if , with the callee's remaining parameters left as whatever the call site happens to leave in the argument registers. Driver implementations dereference these values: get_capabilities() typically reads dev->config/dev->data (a wild read through a non-pointer field of struct net_if), and get_config() implementations write through the uninitialized struct ethernet_config * argument. The practical impact is undefined behaviour in the network RX path - crashes and uncontrolled memory corruption - plus mis-handling of the packet when a capability bitmask is returned as a net_verdict. The attacker controls neither the corrupted address nor the value written, so this is a denial-of-service and memory-corruption issue rather than a controllable write primitive. The same defective fall-through is reachable through any_recv() in subsys/net/l2/dummy/any/any.c, which passes a dummy interface whose struct dummy_api is shorter than the offset read, producing an out-of-bounds read of the driver's API object followed by an indirect call. The fix drops any packet whose interface is not a Virtual L2 interface, closing both entry points.

Why it matters now

Exploitation None reported CISA SSVC · not in CISA KEV
Fix Fixed zephyr (zephyrproject): 4.3.2, 4.5.0

SSVC decision points

CISA ADP · SSVC 2.0.3

Exploitation
None
Automatable
No
Technical impact
Partial

The decision (Track, Attend, Act) also depends on your mission and well-being impact; see CISA's SSVC guide.

Affected products

VendorProductAffected versionsFixed inStatusSource
zephyrprojectzephyr4.2.0 to before 4.3.2; 4.4.0 to before 4.5.04.3.2, 4.5.0Patch availableCNA
  • zephyr Vendorzephyrproject Affected 4.2.0 to before 4.3.2; 4.4.0 to before 4.5.0 Fixed in 4.3.2, 4.5.0 Patch available CNA

CPE names Threatist (inferred) · 1

Inferred from how NVD named this product before; not given by a source.

CPEVersionsRoleVendor
cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:*——zephyrproject
  • cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:* Versions — — ·zephyrproject

Remediation

Zephyr 4.3.2 and 4.5.0 fix the flaw. Upgrade to 4.3.2 or to 4.5.0.

Written with Claude Haiku 5.5 from the sources below · 2026-11-16

  • Fix · CNA zephyr (zephyrproject) Fixed in 4.3.2, 4.5.0

Fixed in the same release

Records fixed by the same vendor advisory or release, as the CNA lists them.

  • Release ·

    zephyrproject zephyr 4.3.2, 4.5.0

    6 records Highest priority Priority LOW 6 LOW

    Other records, highest priority first

    • TI-2026-92325 NULL pointer dereference in Zephyr Bluetooth ATT request lookupPriority LOW 39
    • TI-2026-92326 Zephyr WebSocket client accepts partial Sec-WebSocket-Accept handshakePriority LOW 37
    • TI-2026-92322 NULL pointer dereference in Zephyr ITE IT8xxx2 SHI host command backendPriority LOW 37

Timeline

  1. 2026-11-16 Threatist record created from CVE-2026-93667
  2. 2026-11-17 CISA SSVC decision points changed

References

  • TI-2026-04422 Out-of-bounds read/write in HTTP WebSocket upgrade via non-null-terminated Sec-WebSocket-Key CVSS 3.1CRITICAL 9.8
  • TI-2026-01361 dns: memory‑safety issue in the DNS name parser CVSS 3.1CRITICAL 9.8
  • TI-2026-09174 Unterminated URI buffer causes out-of-bounds read in LwM2M firmware pull (Package URI) CVSS 3.1CRITICAL 9.1
  • TI-2026-09168 Stack buffer overflow in `net_ipaddr_parse()` IPv4 address-with-port parsing in `subsys/net/ip/utils.c` CVSS 3.1CRITICAL 9.8
  • TI-2024-09625 net: lib: http_server: Buffer Under-read CVSS 3.1HIGH 8.6
  • TI-2021-02863 Usb bluetooth device ACL read cb buffer overflow CVSS 3.1CRITICAL 9.6
See all 366 →

Sources

This product uses the NVD API but is not endorsed or certified by the NVD. Sources and licences