Unvalidated PTP interval in Zephyr lets a peer stall time sync
Key facts
- Attack vector
- Adjacent network
- Privileges required
- None
- User interaction
- None
- Attack complexity
- Low
- Impact type
- Denial of service
- Confidentiality · integrity · availability
- None · None · High
- Fix status
- Fixed
Attack profile from CVSS 3.1 · CNA. Fix status from CNA. Impact type from CWE-400.
Summary
Zephyr from 3.7.0 before 4.3.2 and from 4.4.0 before 4.5.0 accepts an unvalidated logMessageInterval field from Delay_Resp messages in its IEEE 1588 PTP port implementation. A crafted value makes the Delay_Req timer arm with a zero timeout or an undefined shift, which leads to uncontrolled resource consumption (CWE-400). An unauthenticated attacker on the same link can send one crafted Delay_Resp message, which stalls the PTP thread until reboot or causes a sustained multicast flood. The impact is availability of the PTP subsystem and the local network segment, with no memory corruption or data disclosure.
Written with Claude Haiku 5.5 from the sources below · 2026-11-10
Description from the CNA
The IEEE 1588 (PTP) port implementation in subsys/net/lib/ptp/port.c adopted the logMessageInterval field of a received Delay_Resp message without any validation. port_delay_resp_msg_process() stored the raw wire value (a full-range int8_t) into port_ds.log_min_delay_req_interval, and that value is later used as a shift count by port_timer_set_timeout() when the Delay_Req timer is armed. Values below about -30 truncate the computed timeout to zero, and values with a magnitude of 64 or more perform an undefined shift of a uint64_t; the standards-defined "not applicable" encoding 0x7F fell into the latter case as well. PTP messages are received over unauthenticated link-local traffic (UDP multicast on 224.0.1.129, IPv6 multicast, or raw IEEE 802.3), and the handler accepts a Delay_Resp from any sender as long as the port is a time receiver using the end-to-end delay mechanism and the message echoes the port identity and a pending sequence id — both of which the victim itself broadcasts in its Delay_Req. Any node on the same link can therefore inject a single crafted Delay_Resp, or simply become the time transmitter and advertise the bogus interval. Once the delay timer is armed with a zero timeout, the cooperative PTP thread re-arms and retransmits a Delay_Req on every tick. Each transmission takes a buffer from the fixed CONFIG_PTP_MSG_POLL_SIZE message slab (default 10) and holds it on port->delay_req_list for three seconds, so the slab is emptied within milliseconds and ptp_msg_alloc() then blocks with K_FOREVER inside the only thread that frees those buffers — permanently stalling time synchronization until reboot. Where a transmit-timestamp callback on another thread keeps recycling buffers, the result is instead a sustained multicast Delay_Req flood and continuous CPU consumption. There is no memory corruption and no disclosure of data; the impact is availability of the PTP subsystem and of the local network segment. The fix rejects intervals outside a representable range and treats 0x7F as "not applicable" as required by IEEE 1588-2019 Table 42. The equivalent unchecked adoption of logMessageInterval from Sync messages in port_sync_msg_process(), a weaker variant of the same issue, is fixed by the companion change 334bf57f416f (#118150), which applies the same range check, ignores the field for unicast Sync messages and treats 0x7F as not applicable.
Why it matters now
SSVC decision points
CISA ADP · SSVC 2.0.3
- Exploitation
- None
- Automatable
- No
- Technical impact
- Partial
The decision (Track, Attend, Act) also depends on your mission and well-being impact; see CISA's SSVC guide.
Affected products
| Vendor | Product | Affected versions | Fixed in | Status | Source |
|---|---|---|---|---|---|
| zephyrproject | zephyr | 3.7.0 to before 4.3.2; 4.4.0 to before 4.5.0 | 4.3.2, 4.5.0 | Patch available | CNA |
- zephyr Vendorzephyrproject Affected 3.7.0 to before 4.3.2; 4.4.0 to before 4.5.0 Fixed in 4.3.2, 4.5.0 Patch available CNA
CPE names Threatist (inferred) · 1
Inferred from how NVD named this product before; not given by a source.
| CPE | Versions | Role | Vendor |
|---|---|---|---|
| cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:* | — | — | zephyrproject |
- cpe:2.3:o:zephyrproject:zephyr:*:*:*:*:*:*:*:* Versions — — ·zephyrproject
Remediation
Upgrade Zephyr to 4.3.2 or 4.5.0, which fix the issue for the 3.7.0 to 4.3.2 and 4.4.0 to 4.5.0 ranges respectively. The fix is in the companion change 334bf57f416f (#118150), which also covers the related Sync message handling.
Written with Claude Haiku 5.5 from the sources below · 2026-11-10
- Fix · CNA zephyr (zephyrproject) Fixed in 4.3.2, 4.5.0
Fixed in the same release
Records fixed by the same vendor advisory or release, as the CNA lists them.
- Release ·
zephyrproject zephyr 4.3.2, 4.5.0
5 records Highest priority Priority MEDIUM 1 MEDIUM, 4 LOW
Other records, highest priority first
- TI-2026-89513 Out-of-bounds write in Zephyr HTTP/2 static file handlerPriority MEDIUM 47
- TI-2026-89516 Simulated EEPROM driver signed offset bypass allows out-of-bounds kernel accessPriority LOW 35
- TI-2026-89517 NULL function pointer call in Zephyr UART wide-data syscallsPriority LOW 24
Timeline
- 2026-11-10 Threatist record created from CVE-2026-87042
- 2026-11-12 Priority changed: MEDIUM → LOW
- 2026-11-13 CISA SSVC decision points changed
References
More zephyrproject vulnerabilities
- TI-2026-04422 Out-of-bounds read/write in HTTP WebSocket upgrade via non-null-terminated Sec-WebSocket-Key CVSS 3.1CRITICAL 9.8
- TI-2026-01361 dns: memory‑safety issue in the DNS name parser CVSS 3.1CRITICAL 9.8
- TI-2026-09174 Unterminated URI buffer causes out-of-bounds read in LwM2M firmware pull (Package URI) CVSS 3.1CRITICAL 9.1
- TI-2026-09168 Stack buffer overflow in `net_ipaddr_parse()` IPv4 address-with-port parsing in `subsys/net/ip/utils.c` CVSS 3.1CRITICAL 9.8
- TI-2024-09625 net: lib: http_server: Buffer Under-read CVSS 3.1HIGH 8.6
- TI-2021-02863 Usb bluetooth device ACL read cb buffer overflow CVSS 3.1CRITICAL 9.6
Sources
This product uses the NVD API but is not endorsed or certified by the NVD. Sources and licences